How to Remove the Rear Cover

 DISCLAIMER: These video presentations are not intended to be all-inclusive instructional videos nor offer advice on appliance repair. They merely illustrate the process. These videos take a lot for granted such as, but not limited to, safety around electrical devices, proper choice and use of hand tools, techniques to ensure personal safety, protection of property, fire safety, and more. By viewing. listening to, or watching this or any other video on the Hottop USA website you assume all responsibility and release Hottop USA and all its employees and contractors from any and all liability. If you do not accept these terms and/or your local laws prohibit such a release of liability, you may not watch or use the information in these videos.

To replace the Rear Cover, reverse the above procedure:
  • For "-2" models, be sure to first replace the return spring in the cover.
  • Align the rear cover to the roaster. Examine the entire outer perimeter of the cover for proper fit. If alignment is difficult, start along one side and work your way down, then work on the opposite side. Having an assistant may be helpful if you are having difficulty in aligning the cover.
  • Loosely install all screws before tightening.
  • Check alignment and tighten the screws until snug.
  • On "-2" models replace the emergency eject knob. DO NOT cross thread the screw!