Repair Procedure
Main Circuit Board
Click on the small images on this page to see a higher-resolution version of the image. The larger image will open in a new window that can be closed after viewing

Begin by following these procedures:
Bearing Plate and Drum
Remove Fan
Remove Rear Cover
Remove Base

1 With the Base free of the machine, the main board is easily accessed. Begin by removing the remaining wires as indicated here. The two power leads (on the right), the two Agitation Motor wires (on the left), and the polarized plug that connects the cooling fans to the main board.

2 Nest, remove the five screws that secure the main board to the base (one screw is concealed by the heat sink in the upper left hand corner in this picture).

To complete the process, reassemble the following:
Replace Base
Replace Rear Cover
Replace Fan
Replace Bearing Plate and Drum
Back to the REPAIR main page